srakaapp.blogg.se

1. TARGUS DRIVERS PAWM10 HOW TO
2. TARGUS DRIVERS PAWM10 DRIVER
3. TARGUS DRIVERS PAWM10 CODE
4. TARGUS DRIVERS PAWM10 PC

To activate the mouse, touch the sensor strips on the side with your hand. Low battery indicator Sensor strips Mouse When power is on, the mouse goes into "sleep mode" after 8 minutes of no use. Mouse Power Management To power the mouse on and off, slide the on/off switch at the bottom of the mouse to the desired position.

2 Press and release the reset button, located on the bottom of the mouse. The receiver’s status light blinks when the receiver is activated. The USB connector rotates 90 degrees to facilitate easy connection to your computer. 1 Press and release the link button on the receiver. To do this, follow the instructions below: Make sure that your computer is turned on and has detected the USB receiver before you establish a communications link.

TARGUS DRIVERS PAWM10 CODE

To establish this link, you need to set the identification code so that the mouse works properly.

TARGUS DRIVERS PAWM10 DRIVER

After your computer detects the USB receiver and the driver software is installed, you must establish a communications link between the mouse and its receiver BEFORE you can use the mouse. The optical sensor, located on the bottom of the mouse, glows red.Įstablishing a Communications Link The RF mouse has 256 identification codes that allow the mouse and its receiver to operate without interference from other radio frequency devices. 5 Turn on the mouse be sliding the on/off switch on the bottom of the mouse to the “on” position. 4 Slide the battery cover back into position until it “clicks” firmly into place. Avoid mixing new and used batteries in a device. Never use an alkaline with a NiMH battery in a device. WARNINGS: When replacing the batteries, you may use alkaline or other heavy-duty NiMH batteries. NOTE: The battery cover is also the top cover of the mouse.ģ Insert the supplied batteries, making sure that the positive (+) and negative (-) ends of each battery match the polarity indicators inside the battery housing. 2 Remove the battery cover from the top of the mouse by pressing the battery cover hinge located on the bottom of the mouse and sliding it off. Using the RF Mouse Installing the Batteries 1 If the mouse is on, slide the on/off switch on the bottom of the mouse to the “off” position. Follow any on-screen procedures to complete the default driver installation. 2 Your computer’s operating system identifies the receiver and begins installing the default driver. If you use the RF mouse with a different operating system, it will lose its enhanced features and function as a standard, twobutton mouse.Ĭonnecting the Mouse Receiver To connect the mouse receiver: 1 Plug the USB receiver into an available USB port on your computer.

TARGUS DRIVERS PAWM10 PC

TARGUS DRIVERS PAWM10 HOW TO

This user’s guide describes how to connect the mouse receiver to your computer, install default software drivers and set up the radio link. No line-of-sight between the mouse and its receiver is required. This ergonomically designed mouse uses a radio frequency (RF) link that enables you to use the mouse anywhere within four feet of its receiver. TARGUS WIRELESS RF MOUSE Introduction Congratulations on your purchase of a Targus Wireless RF Mouse. LONDON PARIS NEW YORK LOS ANGELES TORONTO HONG KONG SYDNEY USER’S GUIDE Making Your Mobile Life Easier.®

© 2004 Targus Group International and Targus, Inc. Visit our Web site at: Features and specifications are subject to change without notice. Používám tuto aplikaci a získat Ft232r usb uart 圆4 řidiče v mrknutí oka. įantastický Ft232r usb uart 圆4 ke stažení.

Zdraví Buddy! To Ft232r usb uart 圆4guide je skvělé! Díky.